The servo drive produces cumulative error during normal operation

The servo drive produces cumulative error during normal operation

SD700 servo driver alarms during operation and the fault code is er320

SD700 servo driver alarms during operation and the fault code is Er320

The output is abnormal after the touch screen is disconnected from the PL

Fault Name:The output is abnormal after the touch screen is disconnected from the PLC.
Fault Symptom:After disconnecting the touch screen from the PLC, the inverter stops running and runs normally after being turned on.

IOT platform does not monitor data

Fault Name: IOT Platform (8028) does not monitor data.Fault Symptom: Quanzhou Office business feedback that platform 8028 cannot monitor the data and operation of the relevant GPRS of Xiamen Weili Chuang Cor. after logging in.

Solution of SD600A servo driver reports encoder fault (Er007)

Fault Name: SD600A servo driver reports encoder fault (Er007).Symptom: When the SD600A servo drive starts and stops frequently, it is easy to report Er007, and it does not report this fault during normal operation or shutdown.

Solution of great noise on SD700 servo motor during rotation

Fault Name:Great noise on SD700 servo motor during rotation.Fault Symptom:SD700 series servo motors generate too much noise during rotation at site or in the laboratory.

Solution of SD700 over-voltage troubleshooting

Fault Name:Over-voltage troubleshooting.Fault Symptom:Er.400 is reported on SD700 servo drive (the following sentences call it over-voltage).

Solution of SD700 over-current troubleshooting

Fault Name: Over-current troubleshooting.Fault Symptom: Er.100 is reported on SD700 servo driver (hereinafter referred to as over-current).

Solution of the servo drive receives no pulses

Fault Name: The servo drive receives no pulses.Fault Symptom:When the PLC sends a pulse to the drive, the drive cannot run and no fault is reported.

Solution of SD600E servo drive er.031 fault

Fault Name: Er.031 is reported on SD600E servo drive.Fault Symptom: Er.031 is reported on SD600E servo drive that causes the machine not to function properly.

Solution of SD600A shearing product length inequality

Fault Name: The lengths of the products cut by SD600A keel equipment are different.Fault Symptom: Customers' feedback mentioned that after the newly installed stainless steel keel equipment is put into operation, except the three materials in the accelerated state of the equipment, the lengths of the sheared out materials are different, and the cutter also gets stuck.

Solution: the motor continues to run at low speed after servo off

The servo speed is given by the analog voltage in speed mode. When the equipment is switched from the running state to the stop state (the analog voltage drop is 0V), the servo motor continues to run at low speed.